Inner Lining - Schubert S2 SPORT Manual

C. THE HELMET
REPLACING THE SUN VISOR
The sun visor can be replaced without tools.
Advice:
To avoid fingerprints and scratches, use a soft, clean cloth
(we recommend a microfibre cloth) to hold the sun visor when
removing or fitting it.
Advice:
It is helpful if you place the helmet on a flat surface or on your lap
while seated.
Note:
Try to prevent the sun visor coming into contact with the helmet's
inner shell when removing or fitting it.
Removing the sun visor
1. Pivot the sun visor down.
2. Bend the middle snap connection with
locating pegs gently outwards until the
sun visor is released from the holder on
one side.
3. Repeat this step for the other side.
Advice:
The sun visor holders should remain in the lower position until you
re-fit the sun visor.
64
Fitting the sun visor
1. Put the sun visor between the snap
connections and fit it on to the locating
pegs on one side and then on the
other.
2. Position the sun visor between helmet
inner and outer shell and lower it with
the operating slide.
3. For safety, check that the sun visor
mechanism is functioning correctly.

12. INNER LINING

The replaceable inner lining of the S2 SPORT is washable and ensures both
an excellent fit and improved ventilation of the helmet.
The high-comfort cheek pads ensure that the helmet fits comfortably
around the cheeks, and the headband pad provides an optimal fit all around
the head. The head pad sits comfortably on the head without covering the
ventilation channels.
All interior fittings are made entirely of skin-friendly material. The material
used for the cheek pads is Coolmax
®
conducts heat and moisture very well, while the headband pad is made from
a special, cooling Thermacool material.
REMOVING THE LINING
Note:
When removing the lining, the cheek pads must first be detached
before taking out the headband pad. When fitting the lining, remember
to insert the headband pad before the cheek pads.
, a soft, breathable material that also
EN
65