Kärcher MIC 50 Manual Del Usuario página 55

ATTENTION
The menu item <Service> is reserved for authorised customer
service personnel.
Menu
1
Selection of <Settings> menu item
2
1. Switch on the ignition.
2. Press the function button for the menu and navigate to <Set-
tings>.
3. Use the function buttons on the navigation display to navigate
within the menu.
4. Select the settings.
5. Press <o>: Confirm selected setting.
6. Press <x>: Return / cancel.
7. Navigate to <Time> in order to set the time.
Setting the time
To save the time and date, the system has to be restarted.
8. Press <o>, the system will be restarted. Date and time are
saved.
9. Press <x> to cancel.
6.8.3 Setting the language on MIC 70
1. Switch on the ignition.
2. Press the function button for the menu and navigate to <Set-
tings>.
3. Confirm using the circle symbol <o>.
4. Use the <Arrow to right> function button to navigate to the
right-hand level.
5. Use the <Arrow down> function button to navigate to the lan-
guage.
6. Select the required language.
7. Switch off the ignition - the selected language is saved.
6.8.4 Settings for working mode
Note
When switching over from TRANSPORT MODE to WORKING
MODE (see chapter8.1 Operating programs), the engine speed
and speed settings are changed.
Note
If the potentiometer for engine speed (see chapter6.11 Operating
consoles) is not in the end position (0), then a display will appear.
If this display appears, turn the potentiometer for engine
speed anticlockwise to the end position (0).
Working mode
In WORKING MODE, it is possible to choose between 3 options.
These options influence the engine speed and hydraulic power.
 30/60 l/min
The engine speed is limited to a max. 1600 rpm, and the hy-
draulic power to 30 l/min, if the hydraulic PTO selector switch
is at 50 l/min.
The engine speed is limited to a max. 1600 rpm, and the hy-
draulic power to 60 l/min, if the hydraulic PTO selector switch
is at 100 l/min.
 40/80 l/min
The engine speed is limited to a max. 2200 rpm, and the hy-
draulic power to 40 l/min, if the hydraulic PTO selector switch
is at 50 l/min.
The engine speed is limited to a max. 2200 rpm, and the hy-
draulic power to 80 l/min, if the hydraulic PTO selector switch
is at 100 l/min.
 50/100 l/min
Maximum hydraulic power and maximum engine speed.
Note
The selected setting is also kept when switching over between
WORKING MODE AND CREEPING MODE.
When switching over to TRANSPORT MODE, the setting is reset
and the engine goes to idle speed.
After an option has been selected, the relevant display will ap-
pear on the display (bottom right).
Changing to the option selection increases or reduces the current
speed, unless the engine is in idle mode.
Press the function button to return to the option selec-
tion.
English 55