Kärcher MIC 50 Manual Del Usuario página 67

1. The attachments are fitted on a Kärcher interchangeable
frame or on an integrated interchangeable frame from the at-
tachment manufacturer, and are fitted and secured on the at-
tachment frame.
Control lever
1
2. The attachment frame is controlled using the control lever at
the right of the joystick.
Switch for "double-acting control hydraulics AUX rear" / "at-
1
tachment frame with tipping function"
3. To activate, switch the switch over to "attachment frame with
tipping function".
9.4.2 Mounting options on the attachment frame
Mounted spreader
1
Interchangeable frame (integrated in the attachment)
2
Attachment frame with tipping function
3
1. Attaching / removing is described using the example of a
mounted spreader.
9.4.3 Setting the fixing
Note
The setting for the fixing of the interchangeable frame must only
be made during first installation or when fitting to another carrier
vehicle.
Screw with nut
1
Fixing hook (2x)
2
Attachment frame
3
1. Undo the nuts to the left and right by about 1 revolution.
2. Fit the attachment to the attachment frame and secure it using
retaining pins and retaining clips, see the following chap-
ter9.4.4 Fitting the attachment to the vehicle.
3. Completely lower the attachment frame.
4. Press the fixing hook against the attachment frame as shown.
5. Re-tighten the nuts to the left and right.
9.4.4 Fitting the attachment to the vehicle
Vehicle rear
1
Retaining pin with retaining clip (2x)
2
Attachment
3
Rear supports
4
Fixing hook (2x)
5
Front supports
6
1. Remove the retaining pins from the attachment frame to the
left and right (retaining pin and retaining clip are a part of the
attachment frame).
2. With the vehicle rear centred and parallel, (carefully) drive un-
der the attachment standing on supports as far as you can go.
English 67