Vel And Ctrl Sections - Steinberg RETROLOGUE2 Manual Del Usuario

Retrologue
Arp Page

Vel and Ctrl Sections

The Vel section is where you set up the steps of the arpeggio and specify their
velocities. In the Ctrl sections, you can edit 3 MIDI controller sequences for the
phrase.
The controller lanes create MIDI controllers 110, 111, and 112, which are sent to
the modulation destinations. When you export a recorded sequence, these
controller values are also exported. This means that once you add the exported MIDI
sequence to the sequencer, you can deactivate the arpeggiator and play the notes
and controller values using the sequencer.
N
Even if you deactivate the arpeggiator in Retrologue, its controller lanes are still
available in the modulation matrix and can be used to modify the modulation using
the incoming MIDI controller messages.
Specifying the Pattern Lenght
•
Activating Steps
A phrase can contain up to 32 steps. Only activated steps are played.
•
Editing Steps
The height of a step represents its value. You can edit the steps in the following way:
•
•
•
•
•
•
OTE
To specify the number of steps for the pattern, drag the Number of Steps
handle in the Vel section to the right or the left.
To activate a step, activate its On/Off button in the Steps section or click it
in the Vel section.
To activate all steps, select Enable All Steps from the context menu.
To adjust a value, click a step and drag up or down.
To adjust multiple steps, click and draw a curve.
To adjust the velocity of all steps relatively, [Shift]-click and drag.
To draw a ramp with steps, hold down [Alt]/[Option] and draw a line.
To draw symmetric ramps at the beginning and the end of the sequence, hold
down [Shift]-[Alt]/[Option] and draw a line.
33