Tempo Section - Steinberg RETROLOGUE2 Manual Del Usuario

Retrologue
Arp Page
Depth
Dest
Mod

Tempo Section

Sync
Tempo
Loop
Tempo Scale
Groove Q
Adjusts the intensity of the influence of the controller lane on the specified
modulation destination
Specifies the destination that is modulated by the controller lane.
Allows you to specify a second source that is used to scale the modulation
intensity. For example, select the modulation wheel to control the intensity.
Synchronizes the phrase to the tempo of your host application.
N
OTE
In addition, you can set Restart mode to Sync to Host. This aligns the phrase
with the beats and measures of your host application.
If Sync is deactivated, you can use the Tempo control to set the internal
playback speed of the arpeggiator. The playback speed of the phrase is
specified in BPM.
If Sync is activated, the Tempo parameter is not available.
If this option is activated, the phrase plays in a loop.
Defines the rate at which notes are triggered, that is, the speed at which the
phrase is running. In addition to the Tempo parameter, this gives you further
control over the playback speed. You can specify a value in fractions of beats.
You can also set dotted and triplet note values.
For example, if Tempo is set to 1/16 and you set this value to 1/8, the speed
is cut in half. If you set it to 1/32, the speed is doubled. Other values increase
or decrease the speed accordingly.
To adapt the timing of a phrase to an external MIDI file, you can drop this MIDI
file on the Groove Quantize drop field.
The Groove Quantize Depth parameter to the right of the drop field
determines how accurately the phrase follows the timing of the MIDI file.
35