Steinberg RETROLOGUE2 Manual Del Usuario página 44

Retrologue
FX Page
Reverb
Mix
High Time
High Freq
Low Time
Low Freq
• To offset the right feedback, turn the control to the right.
N
OTE
This parameter is only available in Stereo mode.
Sets the ratio between the dry and the wet signal.
Controls the reverb time for the high frequencies of the reverb tail. With
positive values, the decay time of the high frequencies is longer. With negative
values, it is shorter.
Which frequencies are affected depends on the High Freq parameter.
Sets the cross-over frequency between the mid and the high band of the
reverb tail. You can offset the reverb time for frequencies above this value
from the main reverb time with the High Time parameter.
Controls the reverb time for the low frequencies of the reverb tail. With
positive values, the decay time of the low frequencies is longer. With negative
values, it is shorter.
Which frequencies are affected depends on the Low Freq parameter.
Sets the cross-over frequency between the low and the mid band of the
reverb tail. The reverb time for frequencies below this value can be offset from
the main reverb time with the Low Time parameter.
44