Steinberg RETROLOGUE2 Manual Del Usuario página 39

Retrologue
FX Page
LFO Modulation Depth
Arp Modulation Source
Arp Modulation Depth
LFO Tab
LFO Waveform and Shape
Adjusts the cutoff modulation from the LFO.
Allows you to select a controller lane from the Arp page as modulation source.
This determines which MIDI controller is used to modulate the cutoff.
Specifies the intensity of the controller lane modulation.
This adjusts the cutoff modulation from the MIDI controller.
The Wave control determines the basic type of waveform. The characteristics
of the selected waveform are modified with the Shape control.
• Sine produces smooth modulation. Shape adds additional harmonics
to the waveform.
• Triangle is similar to Sine. Shape continuously changes the triangle
waveform to a trapezoid.
• Saw produces a ramp cycle. Shape continuously changes the
waveform from ramp down to triangle to ramp up.
• Pulse produces stepped modulation, where the modulation switches
abruptly between two values. Shape continuously changes the ratio
between the high and low state of the waveform. If Shape is set to 50 %,
a square wave is produced.
• S & H 1 produces randomly stepped modulation, where each step is
different. Shape puts ramps between the steps and changes the S & H
into a smooth random signal when fully turned right.
• S & H 2 is similar to S & H 1. The steps alternate between random high
and low values. Shape puts ramps between the steps and changes the
S & H into a smooth random signal when fully turned right.
39