Steinberg RETROLOGUE2 Manual Del Usuario página 34

Retrologue
Arp Page
•
•
•
•
For velocity steps, the width of a step represents its gate length.
•
•
•
•
•
The 3 MIDI controller lanes send the MIDI controllers 110, 111, and 112. By
selecting an arp controller lane as source in the modulation matrix, you can
modulate any of the destinations with the MIDI controller sequence.
Controller Lane Parameters
Bi
To transpose a step, click in the field below it and enter the number of
semitones for the transposition.
N
OTE
You can only transpose steps if the Show Pitch Row button is activated.
To reset the velocity of a step to 127, [Ctrl]/[Command]-click the step.
To reset the velocity of all steps to 127, hold [Shift]-[Ctrl]/[Command] and
click a step.
To introduce a legato between 2 steps, click the number below the first of
these steps, so that a small arrow is shown.
If Legato is activated, the Gate Scale parameter is not taken into account.
To adjust the gate length of a step, drag its right border.
To adjust the gate length of all steps, hold down [Shift] and drag the right
border of a step.
You can only adjust the length this way until a step reaches the next step. If
you increase the gate length of a step so that it overlaps the following steps,
these are deactivated.
To reset the length of a step to 1, [Ctrl]/[Command]-click its highlighted right
border.
To reset the length of all steps, hold down [Shift]-[Ctrl]/[Command] and click
on a highlighted right border.
To fill the gaps between consecutive steps, select Fill Gap or Fill All Gaps
from the context menu.
This button switches the modulation signal to bipolar, to modulate
destinations like pitch or pan, for example.
34