Final Inspection - BERG CYCLES SPORTCROSS Serie Manual Del Usuario

ASSEMBLY
pivot point. Make sure that all fasteners are tight and there is no lateral movement in the rear triangle.
pension system is not maintained, inspected and adjusted as appropriate, may malfunction, this may
cause you to lose control and fall. Changing the suspension settings can modify the characteristics of
handling and braking of the bike. Never change the settings of suspension unless you have an extensive
knowledge of the suspension system, instructions and manufacturer's recommendations, inspect the
bike behaviour with the changes when the bike rides through a careful experimentation, on an area free
SPRING PLATE
FIXATION
BOLT
PISTON
correct. You may lose confidence in using / seriously compromise the functioning.
For more information please consult page 56 to 57.

FINAL INSPECTION

After making all adjustments, place all the gears several times at different speeds. This will ensure that
all settings are correct allowing you to locate any problematic areas. If you have any problems, consult
the appropriate section and make the necessary adjustments.
Check the tire pressure and fill each chamber as recommended (pounds per square inch = psi), as estab-
lished in the tire. Make sure the stand works smoothly and if the screw is tightened.
Finally, examine the bike. Make sure that all accessories are placed and all quick release levers, nuts
and bolts are tightened.
Proper maintenance of your bike guarantees years of enjoyable rides.
Perform maintenance to your bike regularly reviewing the relevant sections of this manual, or taking it
to a bike shop where you can consult professionals technicians.
Always wear a helmet and obey all traffic regulations.
30
// USER'S MANUAL
All manuals and user guides at all-guides.com
SPRING
ADJUSTMENT
PLATE
The degree of displacement of the rear suspension
can be adjusted by turning the adjustment plate.
Turning in a clockwise direction, the spring ten-
sion will increase and will reduce the displace-
ment, while rotating in the opposite direction the
spring tension will decrease and increase the dis-
placement. There are many types of suspension
systems, too many to be treated individually in
this manual. There must be enough tension in the
spring to hold the spring plate in place. If not, it
is possible that the mechanism fails. If the sus-
of hazards. If your bicycle has a suspension kit,
and you want to increase speed, remember that it
will also increase the risks. When braking, the bike
front suspension will low.
You may lose control and fall if you don't have the
capacity to handle with this system. Learn to han-
dle the suspension system safely before downhill
at high speed.
If your bike is equipped with an air damper you
should consult the manufacturer's manual ( if it
exists). For more information on the functioning
and pressure contact the Berg Cycles Technical De-
partment.
Never forget the periodic reviews of your shocker.
Do not use your bike if the shock pressure is not