SWM RS 125 R 2020 Manual Del Usuario página 101

Quick adjustment (Fig. B)
In the point shown in the figure, fit a bush (a) with
diameter of 35 mm (1.37 in.) (or alternatively a shim
with the same size) and make sure the lower branch
(c) of the chain is slightly taut.
CHAIN ADJUSTMENT (FIG. B)
145 mm (5.7 in.) a 35 mm (1.37 in.)
38
EN -
If this is not the case, proceed as follows:
on the right side, loosen the nut (1) securing the
-
wheel pin;
loosen the lock nuts (2) on both the chain tensioners
-
and operate on the screws (3) to obtain the correct
tension value;
adjust the lock nuts (2) to a tightening torque of 22
-
Nm (2.2 kgm - 16.22 ft/lb) and the wheel pin nut (1), to
a tightening torque of 120 Nm (12.0 kgm - 88.50 ft/lb).
After adjustment, always check wheel alignment and
that the arrow is 35 mm (1.37 in.).