Engine Oil Replacement - SWM RS 125 R 2020 Manual Del Usuario

ENGINE OIL REPLACEMENT

After draining the oil as described above, proceed as
follows:
Unscrew the two screws (1) and remove the cover (2)
-
by slightly rotating it.
Remove the oil filter (3).
-
Check that the spring (4) is in its seat on the bottom
-
of the filter housing.
Note
If the tapered spring (4) is out of its seat, position
its largest diameter in the seat so that it remains
in position.
26
EN -
Check the O-ring (5) status and replace it if worn.
-
Replace the filter (3) and fit it on the cover (2).
-
Refit the cover (2) with the filter in the proper housing
-
and start the screws (1) (10 Nm, 1.0 kgm, 7.37 ft/lb).
Note
Make sure that the cover holes match those of the
ducts on the crankcase side.