Removing The Rear Wheel - SWM RS 125 R 2020 Manual Del Usuario

REMOVING THE REAR WHEEL

Unscrew the nut (1) of the wheel pin (3) and extract it.
It is not necessary to loosen the chain tensioners (2);
in this way, the chain tension will remain unchanged
after reassembly. Extract the complete wheel, paying
attention to the spacers located at the hub sides.
To reassemble, reverse the above procedure
remembering to insert the brake disc into the calliper.
(Tightening torque of the nut (1) 120 Nm / 12.0 Kgm /
88.50 ft/lb.).
42
EN -
Note:
Do not operate the rear brake pedal when the wheel
has been removed; this causes the calliper pistons
to move forwards.
After removal, lay down the wheel with brake disc
facing up.
After reassembling the wheel, depress the brake pedal
until the pads are against the disc.
TYRES
Always keep the tyres properly inflated. Their pressure
must always correspond to that specified in the
"Technical data" table at the beginning of the manual.
Replace the tyre if its wear exceeds the reference
values on the table below.
FRONT REAR
3 mm (0.12 in) (RS); 3 mm (0.12 in) (RS);
2 mm (0.08 in) (SM) 2 mm (0.08 in) (SM)