Initial Operation And Configuration; Language And Country; Data Transmission; Software Updates - Porsche Mobile Charger Connect Manual De Instrucciones

Set up
Disconnecting cables
Fig. 37: Disconnecting cables
b Charging of the high-voltage battery has ended
and the vehicle plug has been removed from the
vehicle charge port.
b The plug has been disconnected from the elec-
trical socket.
1. Remove screw C (Fig. 37) using a suitable tool.
2. Lift lever A (Fig. 37).
3. Pull out plug B (Fig. 37) until you first feel resist-
ance.
4. Close lever A (Fig. 37).
5. Pull out plug B (Fig. 37) fully.
66
Securing cables
Fig. 38: Connecting cables and securing plugs
b Lever A (Fig. 38) is closed.
1. Insert plug B (Fig. 38) into the control unit until
you first feel resistance.
2. Lift lever A (Fig. 38).
3. Push plug B (Fig. 38) in fully.
4. Close lever A (Fig. 38).
5. Secure plug B (Fig. 38) to the control unit using
screw C (Fig. 38).

Initial operation and configuration

Start-up
Configure the following settings before starting to
use the charger for the first time.
Information
−
Options marked Skip can be skipped. A setting is
not configured in this case.
−
Settings can be changed on the display at any
time ( ).

Language and country

1. Select the required language from the list. Con-
firm selection.
2. Select the required country from the list.
3. Confirm the selected language and country.

Data transmission

e
Read and confirm instructions for transferring
data.

Software updates

In order to guarantee the full functionality and reliable
operation of the charger, the latest software must
always be installed.
e
Select and confirm settings for the automatic
software update.
On The charger checks whether software up-
dates are available and downloads them auto-
matically.
The installation can then be started directly or
postponed to a later time.