EN
I. S
I - U
ECTION
I.1 General features
I.1.1 Declared conditions of use
EQPI3X units are air cooled multi-purpose total heat recovery units with axial
fans.
They are intended to be used in air conditioning systems or industrial
processes where chilled or hot water is required in every season, simulta-
neously or separately, in 2 or 4-pipe systems, not for domestic use or direct
human consumption.
The units are designed for outdoor installation.
DANGER!
The machine has been designed and built solely and exclusively to
operate as an air-cooled water chiller; any other use other than this is
expressly FORBIDDEN.
Installing the machine in an explosive environment is prohibited.
DANGER!
The units are designed for outdoor installation. Segregate the unit if
installed in areas accessible to persons under 14 years of age.
IMPORTANT!
The unit will function correctly only if the instructions for use are
scrupulously followed, if the specified clearances are complied with
during installation, as well as the use restrictions indicated in this
manual.
2
Number of compressors
70÷130
Approximate cooling power (in Kw)
The power value used to identify the model is approximate, for the exact
value, identify the machine and consult the Technical Data.
I.1.2 Versions
X
High efficiency versions, with a larger condensing section (EQPI3X).
S
Super-silenced version complete with soundproofed compressor
compartment, super reduced speed fans and oversized condensing
section (EQPI3XS). The fan speed is automatically increased when
the external temperature increases significantly.
34
SER
EQPI3X
I.1.2 Available installations
Standard
Set-up without pump or tank
PUMP (main heat exchanger side)
P1
Installation with pump
P2
Installation with increased static pressure pump
DP1
Installation with double pump, including an automatically
activated pump in stand-by
DP2
Installation with increased static pressure double pump,
including an automatically activated pump in stand-by
PUMP (secondary heat exchanger/recovery unit side):
PR1
Installation with pump
PR2
Installation with increased static pressure pump
DPR1
Installation with double pump, including an automatically
activated pump in stand-by
DPR2
Installation with increased static pressure double pump,
including an automatically activated pump in stand-by
TANK&PUMP (main heat exchanger side)
ASP1
Installation with pump and storage tank
ASP2
Installation with increased static pressure pump and water
buffer tank
ASDP1
Installation with double pump, including an automatically
activated pump in stand-by and storage
ASDP2
Installation with increased static pressure double pump,
including an automatically activated pump in stand-by and
storage
I.2 Machine identification
The units feature a serial number plate located on the electrical panel; it
bears the machine identification data.