Orbitalum ORBIWELD 38S Manual De Instrucciones página 34

ENGLISH
Information and safety instructions for the responsible body
2. INFORMATION AND SAFETY INSTRuCTIONS FOR
THE RESPONSIBLE BODY
2.1 Requirements for the responsible body
Workshop/outdoor/field application: The responsible body is responsible for safety in the danger zone around the
machine, and should allow only qualified personnel to enter the zone or operate the machine in the danger zone.
Employee safety: The operator has to observe the safety regulations described in this chapter as well as has to work safety-con-
sciously and with all prescribed safety equipment.
The employer undertakes to give the employees clear notice of the dangers arising that are specified in the EMC directives and to
evaluate the workplace correspondingly.
Requirements for special EMC evaluations with regard to general activities, working materials and work­
places*:
TYPE OF WORKING MATERIALS OR
WORKPLACE
Arc welding, manual (including MIG (Metal
Inert Gas), MAG (Metal Active Gas), TIG
(Tungsten Inert Gas)) under observance of
tried-and-tested procedures and without
physical contact to the line
* According to Directive 2013/35/EU
2.2 using the machine
2.2.1 Proper use
The orbital weld heads are intended solely for the following utilization:
• Utilization in combination with an orbital welding power supply of the ORBIMAT series.
• TIG welding of materials and tube dimensions that are specified in these operating instructions (see chap. 4, p. 41).
• Empty unpressurized tubes that are free of contaminations, explosive atmospheres or liquids.
Only protective gases that are classified for TIG welding in accordance with DIN EN ISO 14175 may be used.
Intended use also includes the following points:
• Permanent supervision of the machine during operation. The operator must always be able to stop the process.
• Observing all safety instructions and warning messages in these operating instructions.
• Observing of the further applicable documents.
• Complying with all inspection and maintenance work.
34
ORBITALuM TOOLS GmbH D-78224 Singen www.orbitalum.com
EVALuATION REQuIRED FOR:
Employees without Employees at particular
particular risk risk (with the exception
of those with active
(1)
No
ORBIWELD 38S, 76S, 115S, 170
Employees with active
implants
implants)
(2)
No
[REV. 20230213] OW_ORBIWELD_BA_821060201_00__INH_EN
(3)
Yes