Orbitalum ORBIWELD 38S Manual De Instrucciones página 39

ORBIWELD 38S, 76S, 115S, 170
X Position the forming system correctly.
2.7.7 Tripping over the hose package
If the hose package is under tension, there is the danger that persons may trip over it and be injured.
Furthermore the plug could be pulled out in the process so that, in the worst case an arc may arise between plug and orbital
welding system. Burns and glaring light may be the result.
X Ensure that under no circumstances can people trip over the hose package.
X Do not place the hose package under tension. This also applies to storage of the orbital weld head after dismantling.
X Place the orbital weld head in the transport case after dismantling.
X Ensure that the hose package is connected properly and that the strain relief is attached.
2.7.8 Electric shock
Two electrical potentials are applied during the welding process:
• Potential 1: Rotor / electrode.
• Potential 2: Remaining components of the orbital weld head including clamping inserts and tube.
Danger of an electric shock at simultaneous contact with both potentials during the high-frequency ignition.
Risk of death for people with heart problems or a cardiac pacemakers.
X From the start of the welding process avoid contact with the tube and the housing of the orbital weld head.
2.7.9 Damage to eyes through radiation
During the welding process infrared, glaring and ultraviolet rays arise that can seriously damage the eyes.
X Keep the flip cover and swivel clamp closed during the welding process.
[REV. 20230213] OW_ORBIWELD_BA_821060201_00__INH_EN
Information and safety instructions for the responsible body
Orbitalum Tools GmbH D-78224 Singen www.orbitalum.com
ENGLISH
39