Daub DR Manual De Usuario página 47

8. MAINTENANCE
8.1. Safety instructions
WARNING
6
• Carefully read the safety instructions in section 3. before servicing the machine. This will
prevent possible personal injury or damage to the machine.
• Only qualified personnel may carry out other maintenance on the machine.
8.2. Maintenance schedule
8.2.1. Required tools
• Cold to lukewarm water
• Brush
• Damp cloth
• Plastic scraper
• Compressed air
• Grease
• Pipe spanner
8.2.2. Instructions
Frequency
Daily
Monthly
DR | User manual
Instructions
Clean all used rounding plates (do not forget to clean the
bottom as well) with cold to lukewarm water.
Do not store the rounding plates in the machine, but hang
them on the side brackets of the machine.
Clean the top of the rounding table with a brush, damp
cloth, plastic scraper or compressed air.
Grease all moving parts of the head. Pay particular attention
to the two console shafts 1 (figure 7) and the brass guide
blocks 2 (figure 7).
After cleaning the area under the rounding table (section
8.4.), also grease all the moving parts. Pay particular
attention to the plastic slider 1 (figure 8) and the cross
bearing 2 (figure 8).
Check the tension of the V-belt, and tighten it if the
rounding has started to slow down. Tighten the V-belt on
the right side (outside) of the machine hand-tight using the
hex pipe spanner.
47
www.daub.nl