Publicidad
Idiomas disponibles
Idiomas disponibles
CLEANING
•
SMARTCLEAN
Press
to show "Smart Clean" on the display.
Smart clean
Press
to activate the function: the display will
prompt you to do all actions needed to obtain the best
cleaning results: Follow the indications and then press
when done. Once you have done all steps, when
required press
to activate the cleaning cycle.
Please note: It is reccommended to do not open the oven
door during the cleaning cycle to avoid a loss of water vapor
that could get an adverse effect on the final cleaning result.
An appropriate message will start flashing on the
display once the cycle has finished. Leave the oven to
cool and then wipe and dry the interior surfaces with a
cloth or sponge.
•
DRAIN
The drain function allows the water to be drained in
order to prevent stagnation in the boiler. This product
has been developed in order to automatically run a
drain cycle once cooking has been stopped/has ended.
Approximately 30min after the stop/end of cooking, the
oven will automatically drain the system, moving the
residual water in the drawer (be careful not to remove
the drawer after cooking). Once done, the drawer can
be extracted and emptied.
We recommend emptying the drawer as soon as the
drain is completed, after the cooking cycle.
If needed, a manual drain can in any case be executed
by the user following the instruction below.
Please note: to ensure that the water is cold, it is not possible
to perform this activity before 30 minutes have elapsed from
the last cycle (or the last time the product was powered).
During this waiting time, the display will show the following
feedback "WATER IS HOT".
Select the "Drain" function
with the water drawer properly
inserted in the oven, press
and wait for the cycle
to automatically run. The
average duration for full load
drainage is about one minute.
Once done, the drawer can be
extracted and emptied.
• DESCALE
This special function, activated at regular intervals,
allows you to keep the steam system in the best
condition. Once the function is started, follow all the
steps indicated on the display and press
to start each phase. The average duration of the full
function is around 100 minutes.
Please note: If the function is stopped at any time, the entire
descaling cycle must be repeated.
The display will show you when it is time to run a
Descale cycle (see the table below).
DESCALE MESSAGE
<RECOMMENDED DESCALE>
It appears after around 15 hours of
steam cycles*
<PLEASE DESCALE>
It appears after around 20 hours of
steam cycles*
*considering the default value (4 - Hard) of water hardness
level. The number of hours of steam cycles that must pass
before the Decale messages are shown depends on the water
hardness level set on the appliance.
The descaling procedure can also be performed whenever the
user desires a deeper cleaning of the internal steam circuit.
Before to run the descaling phase, the appliance will
check if some residual water is contained into the boiler,
and a Drain cycle could be performed, if needed. In this
case, you will have to empty the drawer after the Drain
cycle, before continuing with the Descale Phase.
Please note: to ensure that the water is cold, it is not possible
to perform this activity before 30 minutes have elapsed from
the last cycle (or the last time the product was powered).
During this waiting time, the display will show the following
feedback "WATER IS HOT".
»
PHASE 1/2: DESCALING (70 MIN)
When display will show <ADD 0.25 L OF SOLUTION>,
please pour the descaling solution in the drawer. For
best results in descaling, we recommend filling the
tank with a solution composed of 75 g of the specific
WPRO product and 250 ml of drinking water. Make sure
the solution dissolves completely in the water so that
no residue remains. WPRO descaler is the suggested
professional product for the maintenance of the best
performance of your steam function in the oven. For
orders and information contact the after sales service
or
www . whirlpool .
eu. Whirlpool will not be held
responsible for any damage caused by the use of other
cleaning products available on the market.
when done
MEANING
It is recommended to run a
Descale cycle.
Descale is mandatory. It is
not possible to run a Steam
cycle until a Descale cycle
will be carried out.
Publicidad
