Fitting Dump Hose; Fitting The Hose Guide; Fitting The Floor Tool; Lowering The Floor Tool - Numatic TVL850/150 Traducción Del Manual De Uso Original

Machine Set-up Guide
GB

Fitting Dump Hose

Fitting the Hose Guide

The U-bend in the hose prevents water
spillage when the vacuum is switched off.
Refit vacuum hose to the floor tool when
finished.

Fitting the Floor Tool

Note: Raise floor tool before driving to the cleaning area.
The machine will not operate in reverse with the floor tool lowered.
Lower the floor tool arm by moving the release lever to the upper position (Fig.1).
Break-away Floor Tool
The floor tool design incorporates a safety knock-off feature, this allows it to safely
disengage from its mounting should it become caught on an obstruction during
forward movement.
Make sure you do not over tighten the retaining knobs.
Slide floor tool onto bracket.
7mm
Refit vacuum
hose to the
Floor tool when
finished.
Tighten retaining knobs to finger tight and
attach hose.
22
Note: DO NOT
push the vacuum
hose onto the
floor tool with the
floor tool in the
raised position.
1
Lower the floor tool.
Raise the floor tool.