Publicidad
Machine Set-up Guide
GB
!
Fitting the Side Pod Skirts
1
To fit the side pod skirts, first remove the steel retaining strip already fitted to the pod (Fig.1).
Align the steel retaining strip within the locating grooves of the rubber skirt and refit using existing screws (Fig.2).
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.
Fitting the Brushes
Featuring the OBS (Octagonal Brush
System); the brushes push-fit up onto
the chucks making fitting and removal
a simple process.
Push in side pod. Pull the side pod
adjustment lever and set to the top
position.
The side pod will now pull open
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF BEFORE
MAKING ANY ADJUSTMENTS.
Fit middle brush first (brushes will click-fit onto the OBS drive chuck).
Fit outer brush next on both sides.
2
1
Close side pod and while keeping the side
pod pushed in, set to appropriate width
(see Setting the Width Adjustment, page 34)
Safety gloves are recommended for the
changing of used brushes.
28
2
!
Publicidad
