Nussbaum TTC 600 Manual De Instrucciones página 49

(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
DANGER!
This operation can be extremely dangerous.
Do it manually only if you are certain you can keep the wheel balanced.
For large and heavy tyres an adequate lifting device must be used.
10) Move the platform to free the wheel from the spindle.
11) Remove the wheel.
WHEELS WITH 5-PIECE SPLIT RINGS
1) Move the tool carrier arm to its non-working position.
If the rim has been removed from the spindle, put it back on the spindle as described in the section on "CLAMPING THE WHEEL".
2) Lubricate both beads and the rim with tyre manufacturer recommended lubricant.
3) Take the mobile control unit to work position B.
4) Move the platform to be able to place the tyre on it.
5) Lower or raise the spindle to centre the rim and the tyre.
6) Move the platform forward until the rim is inserted into the tyre.
Move forward with the platform until rim is completely in the tyre.
7) Put the split-ring on the rim and (with the lock ring already mounted).
NB: If the rim and the split-ring have slits for fixing devices, make sure they are lined up with each other.
8) Take the mobile control unit to work position C.
9) Move the tool carrier arm to the outside in its work position with the bead breaker disk turned towards the wheel.
NB: If the split-ring is not inserted sufficiently on the rim, move the spindle until the split-ring is by the disk.
Bring the disk forward (with the spindle turning) until you "discover" the O-ring seating.
10) Lubricate the O-ring and its seating.
11) Take the mobile control unit to work position B.
12) Position the locking ring on the rim with the help of the disk as shown in Fig. Y.
13) Move the tool carrier arm to its non-working position and close the spindle arms completely.
Support the wheel so that it does not fall off the spindle.
DANGER!
This operation can be extremely dangerous.
Do it manually only if you are certain you can keep the wheel balanced.
For large and heavy tyres an adequate lifting device must be used.
14) Move the platform to free the wheel from the spindle.
15) Remove the wheel.
DANGER!!
Do not inflate the tyre with the wheel mounted on the spindle.
Tyre inflation is dangerous and should only be done by removing the wheel from the spindle and placing it
inside a safety cage.
49
TTC 600