Optional Accessories; Moving The Machine - Nussbaum TTC 600 Manual De Instrucciones

ATTENTION: All NUSSBAUM accessories are always supplied complete with installation and
operating instructions.
The following optional accessories are available for the TTC 600 tyre changer:
PL Pliers for alloy rims
Used instead of PC, they make it possible to work with alloy rims, without damaging
them.
DP12 Pneumatic bead pressing device
It facilitates tyre mounting end demounting on drop centre where the channel is fairly
distant from the shoulder.
MV Pair of bead clamp
Used on wheels with split ring, they allows bead breaking of both rim and split ring.
GL Set of 4 jaws for alloy rims
Mounted on the jaws of the chuck, they allows to operate on alloy rims without damaging
them.
LG Bead guide lever
It facilitate bead mounting of tubed wheels.
RT Tubeless roller
Mounted on th tool holding arm, it facilitates bead breaking of tubeless wheels.
The TTC 600 tyre changer has got a fork (1, Fig. A) which has been positionned
there on purpose for moving the machine.
Follow these instructions:
1) Low the turntable holding arm (2, Fig. A) completely down.
2) Close completely the jaws of the chuck (3, Fig. A).
3) Bring the sliding table (4, Fig. A) at the end of its travel, near the arm.
4) Insert into the lifting fork a hoisting belt (at least 60 mm wide and of a lenght
sufficient to bring the hook of the belt above the tyre changer).
5) With the special belt ring bring the 2 ends of the belt together and lift with a
sufficiently strong lifting truck.
TTC 600

13. OPTIONAL ACCESSORIES

14. MOVING THE MACHINE

50
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
PL
DP12
MV
GL
LG
RT
4
3
2
1
A