iM3 EVOLUTION Serie Instrucciones Para El Uso página 26

USER'S MANUAL
OVERVIEW OF DISPLAY
Factory Settings
Program 1 Display shows P1: 30
Program 2 Display shows P2: 20
Program 3 Display shows P3: 15
PLUS key: Increase power, maximum 40,
possible during use
MINUS key: Reduce power, minimum 1,
possible during use
*By holding PLUS/MINUS key the values are continuously
increased / decreased.*
Program 1
40,000
Program Key
Fig. 21 - Display Screen Ultrasonic Scaler
ERROR MESSAGES FOR SCALER IF USING THE DISPLAY
DISPLAY DESCRIPTION OF ERROR
Overheating / overloading of electronics
Error 1
Pedal of the foot control pressed during
Error 2
switching on
Error 4 Display keys pressed during switching on
Running time limiter as a result of
Error 5
15 minutes of continuous operation
Error 6 Error with »Piezo Scaler«
Reboot
e.g.: 05 6303
Error
EVOLUTION VETERINARY DENTAL UNITS
rpm
Ncm Ncm
CHANGING / SAVING THE POWER ON
THE ULTRASONIC SCALER
The power can be set at P1, P2, P3
for a minimum of 1 to maximum 40
Step 1: Press the program key (P1,P2 or P3).
Step 2: Increase power
Step 3: Reduce power
Step 4: Press program key P (P1, P3 or P3) for
approximately 2 seconds to save.
The Set values and an acoustic signal is emitted
to confirm that all the settings have been
saved.
SOLUTIONS
> ➊ Disconnect device from power supply
➋ Wait 5 minutes and allow the system to cool
➌ Restart the function
> Do not press the pedal of the foot control
> Do not press the display keys
> Check the pedal of the foot control
> Do not press the pedal of the foot control any more
[release completely]
> ➊ Check that the Piezo Scaler is correctly attached to
the coupling
> ➋ Replace the tips
> Switch the power supply off and on again
> Restart system
> Immediately contact an authorised
iM3 service partner(see pg6)
26 � EN