Corghi EXACT 70 Manual De Uso página 74

have been entered.
The compensation procedure is guided by means
of graphics showing the status or the operations to
be performed on each single sensor.
Fit the clamp and sensor on the wheel,
connect the sensor to the central unit and switch
it on.
Press the ROC key on the sensor control
panel as required by the selected procedure.
Turn the wheel through 180°.
Compensation calculations in progress,
wait for the end of the operation.
Compensation procedure terminated.
Compensation procedure terminated
with a high compensation value. Check that the
rim does not have unacceptable levels of damage
or that the clamp is fitted correctly.
2-point ROC
Select the icon.
Fit the four sensors on the wheels, fit the clamp with
the black handle pointing upward (if working on a
car with bodywork covering part of the wheel, fit the
clamp horizontal with the black handle pointing to
the left), lift the vehicle and proceed with the ROC
procedure.
The 2-point ROC allows the procedure to be con-
tinued with compensation completed on the front
sensors only; it will not be possible to use the rear
sensors at a later point.
1) Turn the wheel, positioning the clamp vertical
with the red handle at the top (red handle on
the left).
2) Start the compensation procedure on the sen-
sor by pressing the ROC key (B fig.25). LED 1
(G fig.25) will start to flash.
3) Level the sensor and engage the brake; the
74
Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
http://www.eichstaedt-elektonik.de
values will be saved as soon as they become
stable. LED 1 switches to constantly on once
the values have been saved.
4) Turn the wheel through 180°, positioning the
clamp vertical with the black handle at the top
(black handle on the left). Press the ROC key
LED 2 (I fig.25) will start to flash.
5) Level the sensor and engage the brake; the
values will be saved as soon as they become
stable. LED 2 switches to constantly on once
the values have been saved.
6) The procedure ends automatically when the
compensation value is within the pre-set lim-
its. If the ROC value is considered too high, it
is displayed on the screen and LEDs 1 and 2
remain constantly on; to continue, accepting
the compensation, press the ROC key. Check
the condition of the rim and that the clamp is
fixed correctly and repeat the compensation
procedure if appropriate.
7) Repeat the procedure on the other wheels.
Once-round ROC
Select the icon.
Raise the vehicle, fit the clamp and sensor on the
first wheel, and proceed with the compensation
operation on it at once.
Allows the procedure to be continued with com-
pensation completed on the front sensors only;
it will not be possible to use the rear sensors at
a later point.
1) Turn the wheel, positioning the clamp vertical
with the red handle at the top (red handle on
the left).
2) Start the compensation procedure on the sen-
sor by pressing the ROC key (B fig.25). LED 1
(G fig.25) will start to flash.
3) Level the sensor and engage the brake; the
values will be saved as soon as they become
stable. LED 1 switches to constantly on once
the values have been saved.
4) Turn the wheel very slowly through 180° in a
clockwise direction, positioning the clamp
vertical with the black handle at the top (black
handle on the left). Press the ROC key LED 2
(I fig.25) will start to flash.
5) Level the sensor and engage the brake; the
values will be saved as soon as they become
Operator's Manual EXACT 70