In the front axle measurement screen
switches between the two pages of values.
returns to normal display mode.
For adjustment of the caster the data, only avail-
able if the steering lock measurement procedure
has been carried out, must be on the screen. The
data are only shown when the front sensors are
levelled.
N.B. On exit from this procedure the caster values
are saved automatically.
Saving of these values means that the procedure
can always be restarted from the last adjustment
made.
If a new steering lock procedure is performed, the
values recalled will be the last ones measured dur-
ing the steering lock sequence.
(12) Second angle measurement
with steering locked
Repetition of the steering axis angle measurement
allows you to check whether errors have been intro-
duced during adjustment of the caster.
The procedure is exactly the same as the first time
the caster, king pin and steering angle difference
values were measured.
Performing the steering lock procedure or
moves the program straight on to front axle meas-
urement.
(13) Second front axle
measurement
Repetition of the front axle measurement proce-
dure allows any corrections to the adjustments
already made.
(14) Printout of the data measured
(fig.42)
To access this function from the rest of the program
select the
icon or the F4 key.
The printout serves to inform the customer about
the operations performed and as a reference for
subsequent checks on the vehicle.
Fill in the heading of the job record
print and/or save the job done using the appropri-
78
Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
http://www.eichstaedt-elektonik.de
ate commands.
when the printout is complete, end the job and
return to the main menu
job
for any further adjustments.
(15) Graphic printouts
The current printed report, supplied in alphanumeric
form, has now been updated with the addition of two
annexes consisting of graphics which illustrate some
information about the vehicle in intuitive form.
The first annex, entitled "Vehicle Condition", shows
the toe, camber and setback values before and
after adjustment.
The second annex, entitled "Chassis Condition",
lists the set-back, track difference, wheel base dif-
ference, side offset and offset values of the axles
after adjustment.
The "Print \ Type" field of the user set-up can be set
appropriately to select the annexes to be printed:
• "Alphanumeric" prints the alphanumeric pages
only.
• "Vehicle Condition" prints the alphanumeric
report and the vehicle condition annex. This
setting is indicated by the
print page status bar.
• "Chassis Condition" prints the alphanumeric
report and the chassis condition annex. This set-
ting is indicated by the
page status bar.
• "Complete" prints the alphanumeric report and
both annexes.
The set-up can be varied on the print page.
PRINT ON FILE. If selected, allows the
data to be printed in a CSV (Comma Separated
Values) file.
COLOUR PRINT. If selected, the printed
reports will be in colour.
and
or restart the
icon in the
icon in the print
Operator's Manual EXACT 70