Corghi Artiglio Uniformity Manual De Uso página 120

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- The machine consists of the six following main units (fig.4):
1. Machine body.
2. Accessories box.
3. Electrical box
4. Monitor
5. Printer
6. Cone holder trolley
- Remove the wooden slat supporting the upper bead breaker arm.
Support the arm before removing the slat, as it could drop suddenly.
- Remove the electrical box, the monitor,
the printer, the accessories and the cone
holder trolley from the pallet.
- To remove the machine from the pallet,
use the lift anchor bolt 1 included to at-
tach a hoist to the machine, as shown in
fig. 5.
This lifting point must be used whenever
you need to change the installation po-
sition of the machine. Do not attempt
to move the machine until it has been
disconnected from the electricity and
compressed air supply systems.
1
7
2
120
CAUTION!
- Remove the lift anchor bolt.
- Remove the monitor from its packaging and
fasten to the relative mount with the four
screws (1, Fig. 6)
3
- Fasten the monitor mount to the column
with the two specific screws (2, Fig, 6)
- Connect the signal cable (3, Fig. 6) and the
6
power cable (4, Fig. 6) to the rear panel of
the monitor.
Artiglio Uniformity User Manual
1
5

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido