using the lever
Both arms move simultaneously during this procedure. Before starting, check that
the lower arm is in the rest position (completely lowered).
- Once the required distance is reached (a gap of 2-3 mm should be left between
the edge of the wheel and the bead breaker disc, see Fig. 29), release the button
and the lever
horizontal movement.
Upper bead breaking (fig. 31)
A - Preload the bead breaker disc with the control
(Fig. 31) (a preload compressing the tyre by
approximately 5 mm is recommended).
B - Activate disc penetration
wheel rotation (using the pedal
simultaneously lowing the bead breaker in small steps
136
(Fig. 28).
CAUTION!
to inhibit any further
(Fig. 31), then start
, Fig. 30) while
Artiglio Uniformity User Manual
28
29
B
30