Tyre Inflation; Safety Regulations - Corghi Artiglio Uniformity Manual De Uso

• Move the gripper to 2 o'clock (sensor at 6 o'clock).
• Position the demounting unit (tool head).
• Lower the swing tool to find the bead.
• Rotate clockwise so that the gripper is at 6 o'clock (sensor at 10 o'clock).
• The bead is now engaged.
• Engage the bead with the demounting head.
• Rotate clockwise to demount the tyre, with the bead breaker disc in the down position.
• Remove the gripper.
• Now demount the tyre underside, taking care not to damage the sensor.
• Refit the valve sensor (if removed).
• Lubricate both tyre beads.
• Place the sensor at 5 or 6 o'clock.
• Set the tyre at an angle of about 45 degrees
• Turn the tyre so that it touches the mounting head and starts to be mounted on the rim.
• Turn the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock.
• Lower the bead breaker to allow a bead presser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of
the tyre inside the open centre during rotation.
• Rotate the tyre and make the necessary adjustments until the upper bead has been
mounted.
• Using a second RunFlat gripper and/or, if available, the bead depressor accessory, may
significantly facilitate this procedure
• Using the bead breaker disc, remove the Run-Flat grippers used.
• Connect the inflation line to the valve for bead insertion.

6.10. TYRE INFLATION

6.10.a. SAFETY REGULATIONS
Artiglio Uniformity User Manual
MOUNTING
DANGER
• RISK OF EXPLOSION
• Never exceed the tyre pressure recommended by
the tyre manufacturer. Always match the tyre and rim
dimensions.
•Take all precautions to avoid serious or fatal injury
EN
151