Maintenance And Repair; Replacing The Finger Chain - Ottobock 8E70 Serie Instrucciones De Uso

2) Clean the product with a damp cloth and mild soap when needed.
Make sure that no liquids get into the product and product components.
3) Dry the product with a lint-free cloth and allow it to air dry fully.
INFORMATION
The hand can be cleaned three times per day on average.
INFORMATION
When using a prosthetic glove, note the cleaning information in the instructions for use for the
prosthetic glove.

9 Maintenance and repair

Certified O&P professionals may carry out minor repairs themselves. These repairs include repla­
cing the finger chain. All other repairs are carried out by an authorised Ottobock Service Centre.

9.1 Replacing the finger chain

Designation
Drift punch
Hammer
Flat nose pliers
Finger chain
Proceed as follows to replace the finger chain:
52
Tools/materials
Included in the tool kit
General workshop supplies
General workshop supplies
9S296 (Included in the tool kit)
1) Open the terminal device and bring the
thumb into opposition.
2) Switch off the product.
3) Set the drift punch onto the left side of the
fixation pin and tap out the fixation pin.
NOTICE! The fixation pin (conical) can
only be tapped out/removed from the
LEFT side.
NOTICE! Avoid strong impacts to the
product and finger motors!
Reference number