Publicidad
C
A6
A7
A1
2.5 Nm ± 10%
A2
A
A1
A2
A3
A5
A2
2.5 Nm ± 10%
A4
A1
2.5 Nm ± 10%
Refitting the LH lower half-fairing
Position LH lower half-fairing (A) by routing its rear lug on the inner
side of gearchange lever (C).
Fit the 4 nylon washers (A2) onto the 4 screws (A1).
Fit nylon washer (A7) onto the screw with narrow collar (A6).
Start the 4 screws (A1) and screw (A6) previously prepared.
Start inner front fastening screw (A3).
Start lower fastening screw (A5).
Fasten LH lower half-fairing (A) by tightening the 4 screws (A1),
screw (A6), screw (A3) and screw (A5) to the specified torques.
Start the screw with high collar (A4) in the position shown in the
figure to fasten the lower half-fairings together.
Tighten screw (A4) to the specified torque.
ISTR 676 / 01
36
Publicidad
