Fastening To The Floor - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

i The other lifting point is on the side of the machine.
4. Take one bolt and one nut out of the plastic bag.
5. Insert the bolt in the shaft for the wheel guard and
hand-tighten the nut.
Fig. 13:
! This is necessary in order to stop the strap slipping
on lifting the machine.
Fig. 14:
6. Attach a 4 m long lifting strap with sufficient load-
bearing capacity (LOADBEARING CAPACITY = 1000
kg; VIOLET COLOR) as shown in Fig. 13.
Fig. 15:
Werther International S.p.A.
Commissioning | MERCURE 200 | 53
WARNING – Defective or incorrectly at-
tached lifting straps!
Risk of injury due to MERCURE 200 falling
down.
¶
Check lifting straps for physical damage
before attaching.
¶
Tighten lifting straps uniformly.
¶
Lift MERCURE 200 carefully.
4.1.2

Fastening to the floor

1. Hoist the MERCURE 200 with a crane. Erect in the
intended area, taking care to comply with the speci-
fied minimum distances.
i To ensure reliable, ergonomic use of the
MERCURE 200, we advise setting it up at a distance
of 500 mm from the nearest wall.
Fig. 16:
Warning – Risk of tipping
Considerable forces are involved in the wheel
balancing process.
¶
The device must be secured to the floor
before using it, following the steps indi-
cated by the manufacturer.
2. Place the MERCURE 200 on the floor in its final posi-
tion and mark the points where to drill the holes on
the base of the machine.
en
|
1 695 109 017 2019-01-07