Cone Holder Assembly; Fitting Wheel Guard - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

en
54 | MERCURE 200 | Commissioning
Fig. 17:
3. Fit the drill with a 14 mm bit and drill 65 mm deep
holes.
! Accurately clean the hole before inserting the plug.
4. Insert the provided plugs, interpose the washers and
tighten with a torque wrench and fastening torque
25 Nm;
Warning – Risk of tipping
The MERCURE 200 must be attached to
the floor in 3 points through screw-plug.
Use bolt holes.
Fig. 18:
Fixation of MERCURE 200
1 Fastening screws
2 Washer
3 Fischer
i Proceed as follows after erecting the machine:
$ Remove the threaded lug.
$ Re-insert the dummy plug in the balance weight
storage tray.
$ Remove the bolt and nut from the shaft (wheel
guard).
|
1 695 109 017
2019-01-07
4.2

Cone holder assembly

¶ Attach the mounts for accessories to the machine us-
ing the bolts included in the scope of delivery.
Fig. 19:
4.3

Fitting wheel guard

1. Attach the wheel guard to the shaft and secure us-
ing the two bolts and nuts included in the scope of
delivery.
Fig. 20:
Werther International S.p.A.

Publicidad

Tabla de contenido
loading

Tabla de contenido