Fitting And Removing The Wheel; Securing The Wheel; Removing The Wheel - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

en 58 | MERCURE 200 | Fitting and removing the wheel
6. Fitting and removing the
wheel
WARNING – Wheel slip!
Risk of crushing of fingers and other body
parts when attaching and removing wheel.
¶
Wear protective gloves.
¶
Wear safety shoes.
¶
Do not place fingers between the wheel and
the shaft.
¶
Heavy wheels should always be handled by
two people.
6.1

Securing the wheel

1. Switch on the MERCURE 200 with the On/Off
switch.
2. Position a suitable cone on the shaft (flange).
Fig. 33: Positioning the appropriate cone on the shaft (flange)
3. Use a wire brush to remove any dirt.
4. Place wheel on shaft directly on the cone.
5. Push the unlocked quick-action clamping nut onto
the shaft and press firmly against the wheel.
Fig. 34: Sliding the (disengaged) quick-locking nut onto the shaft
|
1 695 109 017 2019-01-07
6. Release the lock and turn the quick-action clamping
nut clockwise until the wheel is firmly braced.
Fig. 35: Turning the quick-locking nut in the clockwise direction
" The wheel is secure.
i For a good quality balancing, it is necessary to care-
fully tighten the quick locking ring nut.
6.2

Removing the wheel

1. Turn the quick-action clamping nut anti-clockwise
and release the wheel.
2. Unlock and take off the quick-action clamping nut.
3. Remove the wheel.
Werther International S.p.A.