Fitting And Removing The Flange; Removing Flange; Fitting Flange - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

5. Fitting and removing the
flange
Fitting of the flange is necessary in the following situa-
tions:
R Commissioning
R When changing the type of flange
(universal - 3/4/5 hole*)
R When changing the type of wheel
(passenger car - motorcycle*)
* Special accessories
! Balancing accuracy will be impaired if the flange has
not been properly fitted to the shaft.Before fitting the
flange, clean and degrease (remove corrosion protec-
tion) the cone of the shaft and the flange opening.
5.1

Removing flange

i The MERCURE 200 must be connected to the elec-
tric mains.
1. Press the pedal.
 This blocks the shaft.
2. Slacken off the hexagon socket head bolt.
Fig. 29: Loosening the hex socket head cap screw
3. Unfasten the flange by tapping with a rubber-headed
hammer on the cone end.
4. Pull the flange off the cone.
Fig. 30: Pulling the flange off the cone
" Flange detached.
Werther International S.p.A.
Fitting and removing the flange | MERCURE 200 | 57
5.2

Fitting flange

i Clean and degrease the cone of the shaft and the
flange opening.
1. Press the pedal.
 This blocks the shaft.
2. Slide the flange onto the shaft.
Fig. 31: Sliding the flange onto the shaft.
3. Tighten the hexagon socket head bolt.
Fig. 32: Tightening the hex socket head cap screw
" Flange fitted.
en
|
1 695 109 017 2019-01-07