46 9.3.2 Alu3 Balancing Program - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

i An acoustic signal sounds to indicate that the posi-
tion has been registered.
 The left display shows the currently set rim
width;
 The right display shows rim diameter.
i To complete the measurement, bring the calliper
gauge to stand-by position;
Fig. 41: Display for standard program
i To prevent damage, the electronic vernier caliper
must be moved to the rest position by hand.
Fig. 42:
i The displays do not show rim distance. Correct value
acquisition can however be verified using the keys
(cap.7.2).
i To run one of the other programs, proceed with
acquisition of the subsequent points.
i For the standard program, rim data input can be
concluded as follows:
$ Manual: Input of rim width with appropriate key;
$ Automatic: Measurement of rim width with gauge
arm *.
*Special accessories
Werther International S.p.A.
Balancing a wheel | MERCURE 200 | 63
9.3.2 Alu3 balancing program
1. Place the electronic calliper gauge on the distance
and diameter of the rim in correspondence of the
first balancing plane (edge of the rim) and keep it in
this position for one second.
i An acoustic signal sounds to indicate that the posi-
tion has been registered.
2. Next, without bringing the electronic calliper gauge
to home position, position it in correspondence of
the second balancing plane and keep it in this posi-
tion for one second.
Fig. 43:
i The second measuring point is displayed.
i An acoustic signal sounds to indicate that the posi-
tion has been registered.
 The left display shows the currently set rim
width;
 The right display shows rim diameter.
i To complete the measurement, bring the calliper
gauge to stand-by position;
Fig. 44: Display for Alu3 program
i To prevent damage, the electronic vernier caliper
must be moved to the rest position by hand.
i The displays do not show rim distance. Correct value
acquisition can however be verified using the keys
(cap.7.2).
en
|
1 695 109 017 2019-01-07