53 9.8 Fixing Of Spring-Clip Weights; 54 9.9 Fixing The Adhesive Weights - WERTHER INTERNATIONAL MERCURE 200 Manual De Instrucciones

i To terminate the Split program and go back to
displaying only the balancing weight, press <SPLIT>
again.
9.8 Fixing of spring-clip weights
i Use the counterbalance clamp to position the spring-
clip weights.
Fig. 55: Counterbalance clamp
1 Bit for removing the spring-clip weight
2 Hammer for fixing the weight on the rim
3 Shear for cutting the adhesive weights
4 Undercut for crushing the spring-clip weight
5 Blade for scraping the adhesive weights
1. Once the correct position of the balancing counter-
balance is reached, rest the spring-clip weight on the
rim edge.
2. Fix the spring-clip weight on the rim using the
weight positioning clamp hammer (2).
Fig. 56:
! Use the bit (1) of the weights positioning clamp to
remove the spring-clip weight.
Werther International S.p.A.
Balancing a wheel | MERCURE 200 | 69
9.9 Fixing the adhesive weights
i Adhesive weight positioning is applied through:
$ with electronic calliper (with AluEasy®);
Fig. 57:
$ With the vernier caliper - Inner weight pliers
Fig. 58:
$ With the vernier caliper - Outer weight pliers
651088-30_Im
Fig. 59:
i In the event that the electronic calliper gauge is
deactivated, use the external clamp to apply the
adhesive weights.
i Use the plastic spatula to remove the adhesive
weights.
en
651076-36_Im
651088-31_Im
|
1 695 109 017 2019-01-07