Hoisting/Handling - Corghi ARTIGLIO 50 Manual De Uso

- Fit the wheel lift (fig. 4c) using the three screws.
- Connect the tank as described on relative
TI manual supplied with the accessory. (T.I.
version only).
- Position the drawer units and rear tool tray
using the screws as shown in figure 4d.
- Connect the pneumatic hose to the pedals
unit respecting the correspondence of the
colors (fig. 4e).
- Connect the pneumatic red hose to the tool
drive cylinder (fig. 4f).
- Connect the pneumatic black hose to the tool head lifting cylinder (fig. 4g).

3.2. HOISTING/HANDLING

To remove the machine from the pallet connect to it by means of the lifting bracket 1
provided, as shown in fig. 5.
This lifting point must be used whenever you need to change the installation position of
the machine. Do not attempt to move the machine until it has been disconnected from
the electricity and compressed air supply systems.
106
4d 4f
Artiglio 50/55 User Manual
4c
4e
4g