Not Approved Uhp And Run Flat Tyre Demounting And Mounting Procedure - Corghi ARTIGLIO 50 Manual De Uso

6.10. NOT APPROVED UHP AND RUN FLAT TYRE DEMOUNTING
AND MOUNTING PROCEDURE
N.B.: if the sensor is on the tyre valve.
• Remove the valve plunger and allow all
the air to discharge from the tyre.
• N.B.: If necessary, remove the valve fixing
nut and allow the sensor to drop into the
tyre.
• Place the sensor at 3 o'clock.
• Lower the bead breaker disc and start
the rotational bead breaking stage.
• Lubricating the bead, continue rotational
upper bead breaking until the sensor is
at 12 o'clock and not beyond.
• Raise the bead breaker disc.
• Move the sensor to 6 o'clock (valve at 12
o'clock).
• Push in the bead breaker disk and fit the
gripper at 2 o'clock.
• Apply plenty of lubricant and then break
the lower bead.
• Move the gripper to 2 o'clock.
• Position the demounting unit (tool head).
• Lower the swing tool to find the bead.
• Rotate clockwise so that the gripper is
at 6 o'clock (sensor at 10 o'clock).
• The bead is now engaged.
• Engage the bead with the demounting head.
• Rotate clockwise to demount the tyre, with the bead breaker disk in the down position.
• Remove the gripper.
• Now demount the underside of the tyre, taking care not to damage the sensor.
• Reinstall the valve sensor (if removed).
• Lubricate both tyre beads.
• Place the sensor at 5 or 6 o'clock.
• Set the tyre at an angle of about 45 degrees.
• Turn the tyre so that it is touching the tyre mounting head and is starting to be mounted
on the rim.
• Turn the tyre until the lower bead is mounted.
• Turn the sensor to 4 or 5 o'clock.
• Lower the bead breaker to allow a bead presser gripper to be inserted at 3 o'clock.
• Lower the bead breaking arm by about 5 cm (2 or 3 inches) to keep the upper bead of
Artiglio 50/55 User Manual
TYRE DEMOUNTING
MOUNTING
42
UK
139