Winding The Bobbin; Removing The Bobbin; Horizontal Spool Pin; Bobbin Winding - Janome 385.4052LX200 Manual De Instrucciones

Winding the Bobbin
Removing the bobbin
Gently slide the hook cover plate release button to the
right, and remove the cover plats.
Lift the bobbin
O Hook cover plate release button
Horizontal spool pin
Lift up the spool pin, Place the spool of thread on the
spool pin with the thread coming off the spool as shown,
[]Ordinary spool
O Spool hoider (Large)
[] Small spool
(_) Spool holder (Small)
• Use the small spool holder for narrow or small
spools,
Note: If the thread tends to tangle around the spool pin,
place the spool stand on the spool pin,
(_) Spool stand
Bobbin Winding
[Guide the thread around the bobbin winder
thread guide.
[]Insert the thread through the hole on the bobbin,
threading from the inside to the outside, Put the
bobbin on the bobbin winder spindle
[]Push the bobbin winder spindle to the righL
With the free end of the thread held in your
hand, depress the foot control,,
Stop the machine when it has made a few turns,
and cut the thread close to the hole on the
bobbin,
Bobbin winder stopper
4mDepress the foot control again When the bobbin
is fully wound, it will stop automatically. Return
the bobbin winder to its original position by
moving the spindle to the left, and cut the thread
as shown.
•. The machine will not sew until the spindle has
been returned to the left position..
Additional spool pin
Insert the additional spool pin into the spool stand and
hole,
Place a felt on the spool pin and place a spool of thread
on it as shown,
(_) Additional spool pin
($) Spool stand
(_) Felt
(_) Hole
J
f
E3
[]
._J
[]
[]
20