Automatic Buttonhole - Janome 385.4052LX200 Manual De Instrucciones

Automatic Buttonhole
Machine setting
0 Stitch pattern:
(_ Presser foot:
(_) Thread tension dial:
(_ Stitch width:
(_) Stitch length:
D
R: Automatic buttonhole
foot
1-5
3-5
0..5-1
The size of buttonhole is automatically set by
placing the button in the rear of the automatic
buttonhole foot R
-4_The button holder of the foot takes a button size
up to 2,5 cm (I) in diameter.
Make a test buttonhole on an extra piece of the
fabric, interfacing and seams of the actual
garmenL
Use the interfacing on the stretch fabrics..
[] Raise the needle by turning the handwheel
toward you.
Raise the presser foot lifter
Attach the automatic buttonhole foot R,
(!) Groove
(_) Pin
[] Pull the button holder to the back @, and place
the button in it.
Push back the button holder toward you (_ as
far as it will go.
(_) Button holder
,_, If the button is extremely thick, make a test
buttonhole., tf it is difficult to fit the button
through the test buttonhole, lengthen the
buttonhole by pulling the button holder back to
create a gap.
O Gap
[_ Pull the buttonhole lever downward as far as it
will go.
(_) Buttonhole lever
[] Insert the fabric under the foot. Turn the
handwheet toward you one rotation and remove
the fabric to the left to draw both threads to the
lefL Insert the garment under the foot, and lower
the needle at the starting point.. Then lower the
automatic buttonhole foot R
(_) Starting point
Note:
Make sure there is no gap between the slider and
spring holder, otherwise the left and right length will be
1different.
(_ Slider
(_) Spring holder
(_) There should be no gap.
Sewing gap
® ® ®
c_:_ -_'_/k_c:_ ....... Sl S2
J
[]
[]
[]
[]
J
36