[Adjusting Buttonhole Stitch Density] - Janome 385.4052LX200 Manual De Instrucciones

[]
Depress the foot control to sew a buttonhole.
The machine will sew the front barrack, left row,
back bartack and right row automatically.. Stop
the machine at the ending point..
@ Ending point
[] Raise the presser foot and cut the both needle
and bobbin threads leaving 10 cm (4")thread
ends..
Draw the needle thread to wrong side of the
fabric by pulling the bobbin thread.
Then, knot the threads
[] Remove the fabric and place a pin just before
the bartack at each end to prevent cutting
barracks Cut the opening with the seam ripper.
@ Pin
1@Seam ripper
< To repeat buttonhole sewing >
[] After a buttonhole is sewn, move the pattem
selector dial to "I" or "2" direction to select
other pattern, then return to" _] "to reset for
sewing the next buttonhole.
@ Pattern selector diai
[] When the buttonhole sewing is finished, push
the buttonhole lever upward as far as it will go.
@ Buttonhole lever
f
%
%D
[]
[]
[Adjusting buttonhole stitch density]
Turn the stitch length dial to the right for a coarser
density
Turn the stitch length dial to the left for a tighter density°
J
m
$I S2
38