Twin Needle Sewing; [Additional Spool Pin] - Janome 385.4052LX200 Manual De Instrucciones

Twin Needle Sewing
Machine setting
(_ Stitch pattern:
(_ Presser foot:
(_) Thread tension dial:
(_ Stitch width:
(_ Stitch length:
Patterns group A
Patterns group B
A: Zigzag stitch foot or
F: Satin stitch foot
2-6
3
_ "$1" for stitch patterns group Ao
., "$2" for stitch patterns group B
f ......
@
={' A :_'B
® ® ®
n e n
_ ---_//_::_ ...... Sl $2
,t, Turn off the power switch before changing the
needle,
-_ When you sew patterns with the twin needle,
test the stitches first before you sew,
Caution: !
Do not set the stitch width at more than 3.,0, or the /
/
needle will hit the needle plate and the needle will breakj
[Additional Spool Pin]
insert the additional spool pin into the spool stand and
hole. Place the felt on the spool pin and place a spool of
thread on it as shown.
(_ Additional spool pin
(_ Spool stand
40 Felt
Hole
i.. Draw both threads from the spools and pass
them through the points from [] to [_
Make sure that the two strings of thread from the
spools will not get tangled
(_ Presser foot lifter
2. The threading step from [] to [] is the same as
single needle threading
3 Slide one of the threads through the needle bar
thread guide on the left, and the other one on
the right.
Needle bar thread guide
4 Thread the needles from the front to back.
O Needle
When changing the sewing direction, raise the
needle and turn the fabric.
x__
.... J
56