Section Ii,Getting Ready Tosew; Connecting Themachine Tothepower Supply; Controlling Sewing Speed; Polarized Plug - Janome 385.4052LX200 Manual De Instrucciones

SECTION I!, GETTING READY TO SEW
Connecting the Machine to the Power Supply
1 Turn off the power switch,
2 Insert the machine plug into the machine socket
3, Insert the power supply plug into the outlet
4 Turn the power switch "ON"
(_ Power switch
Q Machine plug
(_) Machine socket
Q Power supply plug
O Outlet
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs,
Polarized plug
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way,
If the plug does not fit in the outlet, reverse the plug,. If it
still does not fit, contact a qualified electrician to install
the proper outlet Do not modify the plug in any way,
Foot Controller Model YC-482J-1 or TJC-150 is used
with Sewing Machine Model 38&4052LXxxx
(xxx represents numbers 000 through 999).
Replacing the Light Bulb
Unplug the machine.
Do not dismantle the machine other than as
explained in this section,
Warning;
As the light bulb could be HOT, protect your fingers
when you handle it
<Removing the light bulb>
1, Remove the set screw,.
2 Remove the face plate,
3, Push the bulb up and turn it counterclockwise to
remove.
(!) Setscrew
O Face plate
(_ Light bulb
<Attaching the light bulb>
4. Push up the light bulb and turn it to clockwise
5. Attach the face plate.
6, Tighten the screw
®
l
................. )
\
8