Dc-Kit2 With Dometic B1600/Systems With Enable Input; Dc-Kit2 With Dometic Freshjet1100/1700/2200, Freshlight1600/2200 - Waeco ECL-76 Instrucciones De Montaje

Connection
Dometic B1600 Plus/B2200
NOTE
I
B 2200 with a serial number lower than 802200001 must be installed as
described in chapter 7.4.
➤ Remove the B1600 Plus/B2200's outlet panel, if necessary remove the upper cover.
➤ Connect the wire sleeves of the universal connection cable to contacts I5 and I2 on the
charging current distributor.
➤ Join the on/off cable of the B1600 Plus/B2200 (item no. 4441300129) to the plug
connector on the circuit board (fig. i, page 19).
NOTE
I
Guide the on/off cable carefully past the fan.
➤ Connect both the wires on the universal connection cable (4441300124) to the two
wires on the on/off cable of the B1600 Plus/B2200.
7.4

DC-Kit2 with Dometic B1600/Systems with enable input

 Roof air conditioner:
– Dometic B1600
– Systems with enable input approved by the manufacturer
 Circuit diagram: fig. 4, page 6
 Charging current distributor: ECL-102
 Inverter: PP2002
➤ Install the switch, which is connected to the two-wire cable, in an easily-accessible place.
➤ Connect the system plug to the inverter. Divide a wire of the cable in such a way that
the ends produced can be connected to the l2/l3 connectors of the ECL-102 with wire
sleeves. If necessary, extend the wires with a suitable cable.
7.5 DC-Kit2 with Dometic FreshJet1100/1700/2200,
FreshLight1600/2200
 Roof air conditioner:
– Dometic FreshJet 1100/1700/2200
– Dometic FreshLight1600/2200
 Circuit diagram:
– Dometic FreshJet 1100/1700/2200: fig. 6, page 8
– Dometic FreshLight1600/2200: fig. 7, page 9
 Charging current distributor: ECL-102
 Inverter:
– Dometic FreshJet 1100/1700/2200: SinePower SP1500 (Art.-Nr. MSK1500-012)
– Dometic FreshLight1600/2200: PP2002
70
ECL-76, ECL-102
EN