Dc-Kit3 With Dometic B1600/Hb2500 - Waeco ECL-76 Instrucciones De Montaje

Connection
Dometic CA2500
➤ Remove the CA2500's outlet panel.
➤ Connect the charging current distributor to the air conditioner using the 2-wire universal
connection cable (on/off cable, item no. 4441300124).
➤ Connect the wire sleeves of the universal connection cable to contacts 12 and 13
on the charging current distributor.
➤ A cable leading out provides the connection to the circuit board (fig. j, page 19).
Sever this cable and join the resulting cable ends to the universal connection cable.
Dometic B1600 Plus/B2200
NOTE
I
B 2200 with a serial number lower than 802200001 must be installed as de-
scribed in chapter 7.4.
➤ Remove the B1600 Plus/B2200's outlet panel, if necessary remove the upper cover.
➤ Connect the wire sleeves of the universal connection cable to contacts I5 and I2 on the
charging current distributor.
➤ Join the on/off cable of the B1600 Plus/B2200 (item no. 4441300129) to the plug con-
nector on the circuit board (fig. i, page 19).
NOTE
I
Guide the on/off cable carefully past the fan.
➤ Connect both the wires on the universal connection cable (4441300124) to the two
wires on the on/off cable of the B1600 Plus/B2200.
7.7

DC-Kit3 with Dometic B1600/HB2500

 Roof air conditioner: Dometic B1600/HB2500
 Circuit diagram: fig. 0, page 12
 Charging current distributor: ECL-102
 Inverter: SinePower SP1500 (item no. MSK1500-012)
➤ Install inverter remote control MCR-8 (or MCR-9, membrane button) in an easily-acces-
sible place (jumper closed, refer to remote control installation manual) and connect its
cable to the inverter.
➤ Unravel the 2-wire universal connection cable (on/off cable, item no. 4441300124)
so that you have two individual wires.
➤ Use the blue wire of the universal connection cable (item no. 4441300124) to join the I5
connection of the ECL-102 to the MCR-8 (MCR-9) remote control (use wire sleeves).
➤ Use the brown wire of the universal connection cable to join the D+ input to the
l2 connection on the ECL-102 (use wire sleeves).
72
ECL-76, ECL-102
EN