Medizintechnik EasyOne-CS 2001 Manual Del Usuario página 97

2030434-002 Rev. B
PEFT _p
FEF25 _p
FEF50 _p
FEF75 _p
FEF2575 _p
FEV3 _p
FIVC _p
VCmax _p
EOTV _p
PIF _p
FIF25 _p
FIF50 _p
FIF75 _p
Tzero _p
CuFVLen _p
CuVTLen _p
CurveFV _np
CurveVT _np
Notes:
•
In the case of test types 'SVC test', 'MVV' and 'Calibration', the content of certain parameters
will differ from the conventional values. The corresponding values are noted at the end of the
table.
•
Curve data is exported in vertical format so that it can be imported to EXCEL easier.
•
Boolean values: zero designates 'False' and not equal to zero designates 'True'.
•
Suffix p: this suffix is appended to a parameter name if the test is a Post test. Example:
FEV1Best_p designates the best FEV1 value in the Post test. parameters with suffix _p exist only
if a Post test has been conducted.
•
Suffix _np: this parameter suffix is used only for curve data. Up to three curves may be exported
dependent on the Device Configuration: CurveFV_1, CurveFV_2, CurveFV_3. The numbers signify
1 = best test, 2 = second best test, 3 = third best test. The additional suffix p is, in turn, used
for Post tests.
•
CurveFV contains precisely the number CuFVLen of values. The same applies analogously to
CurveVT.
•
Scaling of the FV curve: the flow values in the table have a resolution of 10 ml/s (a value of 10
means a flow of 100 ml/s). The volume spacing between two points is 30 ml. The first measured
value at (0.0) is always omitted.
•
Scaling of the VT curve: The volume values in the table have a resolution of 10 ml (a value of
100 corresponds to 1000 ml). The time spacing between two measurement points is 60 ms. The
first point of the curve at (0.0) is always omitted.
•
Parameters signs: inspiration positive, expiration negative.
3 float Exp. peak flow time [s]
3 float forc. exp. flow 25% [l/s]
3 float forc. exp. flow 50% [l/s]
3 float forc. exp. flow 75% [l/s]
3 float forc. exp. flow 25-75% [l/s]
3 float forc. exp. volume in 3 s [l]
3 float forc. insp. vital capacity [l]
3 float max. vital capacity [l] (FVL only)
3 float Volume at end of test [l]
3 float Insp. peak flow [l/s]
3 float forc. insp. flow 25% [l/s]
3 float forc. insp. flow 50% [l/s]
3 float forc insp. flow 75% [l/s]
3 float Time datum for back-
extrapolation [s]
3 int Length of flow/volume curve
3 int Length of flow/time curve
x int Flow/volume curve
y int Volume/time curve
Rf [1/min] / 2
IRV [l] MVV [l/min]
VCin [l]
IC, insp.Cap.[l]
Page 42
mean exp.
flow
insp. Peak[l/s]