Chin Strap With Double-D-Fastening; Face Shield With Anti-Fog Lens - SCHUBERTH SR2 Manual

C. THE HELMET

9. CHIN STRAP WITH DOUBLE-D-FASTENING

The double-D-fastener allows for an easy and precise adjustment of the chin
strap.
Closing the chin strap
1. Thread the end of the chin strap
through the double-D-fastener.
2. Pull the chin strap tight and feed the
free end back through the front ring.
3. Pull the free end of the chin strap until
it's tight and comfortable on your chin.
4. Take the free end of the chin strap
reverse and affix to the press stud.
Loosing and opening
Release the press stud and pull on the red lug
of the double-D-fastener, so that the chin strap
is loosened.
Thread the free end of the chin strap out of the
double-D-fastener.
Caution:
Never ride without a closed and adjusted chin strap, otherwise you risk
losing the helmet from your head.
44

10. FACE SHIELD WITH ANTI-FOG LENS

The face shield is a fog-free double-lens visor. By fixing the inner anti-fog
lens using eccentric pins, the two visor panes are pre-tensioned together and
are thereby sealed. An insulating air cushion is thus formed between the
visor's main plate – i.e. the outer plate – and the inner plate, which prevents
any fogging up of the inner plate.
COATING
The main plate has a HighClear anti-scratch coating on both sides.
®
Note:
The helmet should never be used to hold gloves or any other objects as
this may damage the scratch-sensitive anti-fog lens.
Note:
The anti-fog lens is supplied with a protective film. Remove this film
before using the helmet for the first time.
Note:
The anti-fog lens may only be used in conjunction with the
SCHUBERTH main face shield that has been specially designed for this
purpose. Other face shields must not be fitted.
OPENING THE FACE SHIELD
To open the face shield, place your thumb under one
of the finger tabs on one side and then push the
shield pane upwards to the desired position.
EN
45