SCHUBERTH SR2 Manual página 26

C. THE HELMET
ANTI-FOG LENS
Fitting
1. Lay the anti-fog lens in the face shield
in such a way that one side of it is
already slotted into the locking pin.
2. Now grasp the other side of the anti-
fog lens by its upper and lower
transverse edges and use your index
finger to gently press the end of the
visor into a slight "S" shape. Now you
can easily guide the slot over the
locking pin and release the anti-fog lens
into place.
3. The anti-fog lens should now be
positioned in the face shield with its
lower edge parallel to the lower edge of
the face shield. If you need to change
the positioning of the anti-fog lens, use
the balls of your thumbs to gently bend
the face shield apart until the inner
visor can be adjusted as required.
4. Check all round the visor to make sure that the anti-fog lens fits tightly
and evenly against the face shield. Only if this is the case will the anti-
misting properties function properly.
5. If you have not done so already, remove the protective film from the
anti-fog lens.
If the anti-fog lens is not air-tight and the face shield mists up, either the
visor is not correctly in place or the pressure on the seal is inadequate.
You can regulate the pressure on the seal by adjusting the eccentric locking
pins.
48
Removal
1. Before starting to remove the anti-
fog lens, first lay the face shield on a
soft, clean cloth so that its top edge is
facing you.
2. To reduce the pretensioning of the anti-
fog lens slightly if necessary, use the
balls of your thumbs to carefully bend
the face shield sufficiently apart while
applying pressure with your thumbs to
release the anti-fog lens and move it
approx. 2-3 mm forward.
3. Now grip the back of the anti-fog lens
with your index and middle fingers and
lift it off the face shield. In this position
you can easily remove the anti-fog lens
from the locking pin with your thumb.
4. You can now remove the anti-fog lens
from the face shield.
Note:
To avoid scratching the face shield, never remove or fit the anti-fog lens
unless the visor unit is clean and dry.
When fitting the anti-fog lens, check that neither dust nor moisture are
able to get between the two plates.
When removing or fitting the anti-fog lens, it is always best to lay the
face shield unit on a clean, dry cloth.
Note:
Due to the high air pressure caused while riding with an open visor, we
generally recommend closing the visor to prevent dirt and moisture
from getting in.
EN
49