SCHUBERTH SR2 Manual página 28

C. THE HELMET
Removing the headband cushion
1. Pull the semicircular guide rail of the
headband cushion out of the slots of
the plastic rail fixed to the inner shell.
2. Pull the retaining strap in the neck area
out of the guide slot between the inner
and outer shells.
FITTING THE LINING
Fitting the headband cushion
The semicircular guide rail stitched onto the face side is used for fixing the
cushion, aided by the retaining strap situated in the neck area.
1. Push the semicircular guide rail
gradually under the gaps of the plastic
rail fixed to the inner shell.
2. Push the retaining strap of the neck
cushion gradually into the guide gap
between the inner and outer shells.
52
3. Arrange the headband cushion within
the helmet ensuring that no air channel
is blocked.
Fitting the cheek comfort pads
1. Fix the cheek pad with the aid of the
red-marked plug-in device.
2. Push the retaining strap of the cheek
pad into the guide gap between the
inner and outer shells. Begin with the
lower part of the pad.
3. Push the retaining strap with a gentle
pressure towards the shell into the
guide gap between the inner and outer
shells.
4. Repeat steps 1-3 with the other cheek
comfort pad.
EN
53