Inlet Cowl; Accessories And Spare Parts; Storing The Helmet - SCHUBERTH SR2 Manual

G. CARE AND MAINTENANCE

4. INLET COWL

The air inlet cowl must be removed before
cleaning:
1. Slide the operating elements of the
inlet cowl to the rearmost position.
2. Then grip the outer edge of the
operating element and release it by
gently pressing it out of the grooves.
3. Clean the inlet cowl and mechanisms.
4. To reattach, insert the inlet cowl
into the grooves of the ventilation
mechanism and push it in until you hear
it click into place.
66
H. ACCESSORIES AND SPARE PARTS

5. STORING THE HELMET

Store the helmet in a dry, well-ventilated and stable location. Always position
the helmet so that it cannot fall to the floor. Damage that occurs in this way
is not covered by the warranty.
Note:
Store the helmet out of the reach of children and animals.

1. ACCESSORIES AND SPARE PARTS

You will find a summary of all of the available accessories and spare parts
on the internet at WWW.SCHUBERTH.COM
Note:
When replacing the cheek pads, the Anti-Roll-Off System must be
properly joined to the chinstrap. For this purpose, the clips on
the free ends of the neck-bands – as shown in the illustration below
– must enclose the corresponding ends of the chinstrap and the
neckbands must not be twisted or knotted.
Caution:
For safety reasons, all other parts of the helmet should be replaced by
the SCHUBERTH Repair Service only.
2. ORDERING ORIGINAL SCHUBERTH PARTS
Original SCHUBERTH parts and accessories are available from your dealer.
To find SCHUBERTH dealers in your area, use the dealer search on the
SCHUBERTH website: WWW.SCHUBERTH.COM
EN
67